Hyundai Creta: Back View Camera System / Description and operation

Description
Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.
  
This system is a supplementary function only. It is the responsibility of the driver or always check the inside/ outside rearview mirror and the area behind the vehicle before and while backing up because there is a dead zone that can't see through the camera.
Schematic diagrams
Circuit Diagram ...

Repair procedures
Removal 1. Remove the tailgate trim. (Refer to Body - "Tailgate Trim") 2. Remove the tailgate back panel. (Refer ...

Other information:

Hyundai Creta GS 2014-2024 Service Manual: Seat Belt Buckle Switch (BS)
Description and operation Description Buckle Sensor (BS) sends driver/passenger seat belt fastened/unfastened status signal to the Smart Junction Box (SJB). If either side seat belt is unfastened, the warning lamp is turned ON in the Cluster, and turned OFF when the seat belt ...

Hyundai Creta GS 2014-2024 Service Manual: Repair procedures
Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Run the engine at idle, then put a finger over the open end of th ...

© 2017-2024 www.hcrmangs.com