Hyundai Creta: Clutch System / Ignition Lock Switch
Specifications
| Specifications |
|
Item |
Specifications |
|
Working voltage |
DC 12V |
|
Operating force |
Initial position : 0.25 ± 0.15N(0.025 ± 0.015kg, 0.056 ± 0.034lb) |
|
Full position : 0.8 ± 0.2 N(0.08 ± 0.02 kgf, 0.579 ± 0.014 lb-ft) |
|
|
Working temperature |
-40°C ~ 80°C (-40°F ~ 176°F) |
Description and operation
| Description |
| – |
Ignition lock switch is mounted on the clutch pedal.
|
| – |
Ignition lock switch is operated when you press the clutch pedal.
|
| – |
If the clutch pedal is not pressed down, the engine is not started.
|
| Ignition lock & clutch switch operating locus |
| – |
If the clutch pedal is pressed down, (A) operate ignition lock switch
at a location.
|
Repair procedures
| Removal |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable.
|
| 2. |
Disconnect the ignition lock & clutch switch connector (A).
|
| 3. |
Remove the ignition lock & clutch switch (A) after removing the bolt
(B-2ea).
|
| Inspection |
| Component Inspection |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable.
|
| 2. |
Remove the ignition lock & clutch switch.
|
| 3. |
Rotate the switch lever to the direction of the arrow to check the operating
point (A).
|
| Installation |
| 1. |
Install is proceeds as follows.
※ How to install the ignition lock & clutch switch
(A) After inserting the switch lever (A) into the clutch pedal pin (B),
pre-tighten the switch mounting bolt (C).
(B) Set the clutch switches so as to confirm that the electric current
is applied to the pins â‘¡ and â‘£.
(C) Fix the clutch pedal to the ignition lock switch OFF/ON strokes
(F).
(D) With the pedal fixed, rotate the switch clockwise and counter-clockwise
to set it to a position at the transition from OFF to ON. Then, tighten
the mounting bolt (C) to the specified torque.
(E) Once completing the assembly, check again that the switch is correctly
operating.
※ OFF→ON stroke tolerance should be within ± 6 mm.
|
Clutch Cover And Disc
Components and components location
Components
1. Clutch release fork
2. Clutch cover assembly
3. Clutch disk assembly
4. Clutch release bearing
R ...
Clutch Switch
Specifications
Specifications
Item
Specifications
Working voltage
DC 12V
Operating force
Initial posi ...
Other information:
Hyundai Creta GS 2014-2019 Owners Manual: Instrument panel fuse replacement
1. Turn the ignition switch and all
other switches off.
2. Open the fuse panel cover.
3. Pull the suspected fuse straight
out. Use the fuse puller provided in
the engine compartment fuse
panel.
4. Check the removed fuse; replace it
if it is blown.
5. Push in a new fuse of the same ...
Hyundai Creta GS 2014-2019 Service Manual: Fuel Pump Motor: Repair procedures
Removal
1.
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump")
2.
Disconnect the electric pump wiring connector (A) and the fuel sender
connector (B).
3.
Remove t ...
© 2017-2026 www.hcrmangs.com
