Hyundai Creta: Heater / Mode Control Actuator

Hyundai Creta GS 2014-2025 Service Manual / Heating, Ventilation and Air Conditioning / Heater / Mode Control Actuator

Components and components location

Components Location

1. Mode control actuator

Description and operation

Description

The mode control actuator is located at the heater unit.

It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.

Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the mode control actuator connector.

Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.

Verify that the mode control actuator operates to the vent mode when connected in reverse.

1. -
2. -
3. Defrost mode
4. sensor ground

5. Feedback signal
6. Sensor (+ 5V)
7. Vent mode

4.	Connect the mode control actuator connector.

5.	Turn the ignition switch ON.

Check the voltage between terminal 6 and 5.

Specification

Door position	Voltage (V)	Error detecting
Vent	0.3 ± 0.15	Low voltage : 0.1V or less
Defrost	4.7 ± 0.15	High voltage : 4.9V or more

It will feedback the current position of the actuator to controls.

7.	If the measured voltage is not within specification, substitute with a known-good mode control actuator and check for proper operation.

8.	Replace the mode control actuator if it is proved that there is a problem with it.

Diagnosis With GDS

The heating, ventilation and air conditioning can be quickly diagnosed failed parts with vehicle diagnostic system (GDS).

※ The diagnostic system (GDS) provides the following information.

(1) Self diagnosis : Checking the failure code (DTC) and display.

(2) Current data : Checking the system input/output data state.

(3) Actuation test : Checking the system operation condition.

(4) Additional function : Other controlling such as he system option and zero point adjustment.

2.	Select the 'Car model' and the system to be checked in order to check the vehicle with the tester.

3.	Select the 'Current data' menu to search the current state of the input/output data. The input/output data for the sensors corresponding to the Mode Control Actuator can be checked.

4.	To perform compulsory operation on Mode Control Actuator input factors, select "ACTUATION TEST".

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Remove the main crash pad assembly. (Refer to Body - "Main Crash Pad Assembly")

3.	Remove the joint connector (A).

4.	Disconnect the connector (A) and then remove the mode control actuator (B) after loosening the mounting screws.

5.	Install in the reverse order of removal.

Temperature Control Actuator

Components and components location Components Location 1. Temperature control actuator Description and operation Description The temperat ...

Auto Defogging Actuator

Components and components location Components Location 1. Auto defogging actuator Description and operation Description The auto defoggin ...

Other information:

Hyundai Creta GS 2014-2025 Service Manual: Back-up Lamp Switch
Description and operation Description Component location : Manual transaxle case Operation principle : Back up lamp switch is pushed by the reverse lug sliding when select arm, and switches the back up lamp. Function : Turn on the back up lamp when reversing. S ...

Hyundai Creta GS 2014-2025 Service Manual: Description and operation
Description Emissions Control System consists of three major systems. • The Crankcase Emission Control System prevents blow-by gas from releasing into the atmosphere. This system recycles gas back into the intake manifold (Closed Crankcase Ventilation ...