(1) Driver’s door power window
switch
(2) Front passenger’s door power
window switch
(3) Rear door power window switch
(Right)
(4) Rear door power window switch
(Left)
(5) Window opening and closing
(6) Automatic power window*
(7) Power window lock switch
The ignition switch must be in the ON position to be able to raise or lower the windows. Each door has a Power Window switch to control that door's window. The driver has a Power Window Lock switch which can block the operation of passenger windows. The power windows will operate for approximately 30 seconds after the ignition switch is placed in the ACC or LOCK/OFF position. However, if the front doors are opened, the Power Windows cannot be operated even within the 30 second period.
To open or close a window, press down or pull up the front portion of the corresponding switch to the first detent position (5).
Pressing or pulling up the power window switch momentarily to the second detent position (6) completely lowers or lifts the window even when the switch is released. To stop the window at the desired position while the window is in operation, pull up or press down and release the switch.
If the power windows do not operate normally, the automatic power window system must be reset as follows:
1. Place the ignition switch to the ON position.
2. Close the window and continue pulling up on the power window switch for at least 1 second.
If the power windows do not operate properly after resetting, it is recommended that the system be checked by an authorized HYUNDAI dealer.
If a window senses any obstacle while it is closing automatically, it will stop and lower approximately 30 cm (12 in.) to allow the object to be cleared.
If the window detects the resistance while the power window switch is pulled up continuously, the window will stop upward movement then lower approximately 2.5 cm (1 in.).
If the power window switch is pulled up continuously again within 5 seconds after the window is lowered by the automatic window reversal feature, the automatic window reversal will not operate.
WARNING
Make sure heads, other body parts or other objects are safely out of the way before closing the windows to avoid injuries or vehicle damage. Objects less than 4 mm (0.16 in.) in diameter caught between the window glass and the upper window channel may not be detected by the automatic reverse window and the window will not stop and reverse direction.
The driver can disable the power window switches on the rear passengers' doors by pressing the power window lock switch to the lock position (pressed).
When the power window lock switch is pressed:
NOTICE
WARNING
Windows
Hyundai Creta GS 2014-2024 Service Manual: Door Scuff Trim
Components and components location
Component Location
1. Front door scuff trim
2. Rear door scuff trim
Repair procedures
Replacement
•
...
Hyundai Creta GS 2014-2024 Service Manual: Components and components location
Components Location
[LHD]
1. Sub frame
2. Steering gearbox
3. Front stabilizer bar
4. Front lower arm
5. Front axle
6. Front strut assembly
7. Drive shaft
[RHD]
1. Sub frame
2. Steering gearbo ...