Hyundai Creta: Rear Glass Defogger / Rear Glass Defogger Printed Heater: Repair procedures

Hyundai Creta GS 2014-2025 Service Manual / Body Electrical System / Rear Glass Defogger / Rear Glass Defogger Printed Heater: Repair procedures

Inspection

•	Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply finger pressure on the tin foil, moving the tin foil along the grid line to check for open circuits.

1.	Turn on the defogger switch and use a voltmeter to measure the voltage of each heater line at the glass center point. If a voltage of approximately 6V is indicated by the voltmeter, the heater line of the rear window is considered satisfactory.

2.	If a heater line is burned out between the center point and (+) terminal, the voltmeter will indicate 12V.

3.	If a heater line is burned out between the center point and (-) terminal, the voltmeter will indicate 0V.

4.	To check for open circuits, slowly move the test lead in the direction that the open circuit seems to exist. Try to find a point where a voltage is generated or changes to 0V. The point where the voltage has changed is the open-circuit point.

Use an ohmmeter to measure the resistance of each heater line between a terminal and the center of a grid line, and between the same terminal and the center of one adjacent heater line. The section with a broken heater line will have a resistance twice that in other sections. In the affected section, move the test lead to a position where the resistance sharply changes.

Repair of Broken Heater Line

Prepare the following items :

1.	Conductive paint.

2.	Paint thinner.

3.	Masking tape.

4.	Silicone remover.

Using a thin brush :

Wipe the glass adjacent to the broken heater line, clean with silicone remover and attach the masking tape as shown. Shake the conductive paint container well, and apply three coats with a brush at intervals of about 15 minutes apart. Remove the tape and allow sufficient time for drying before applying power. For a better finish, scrape away excess deposits with a knife after the paint has completely dried. (Allow 24 hours).

Components and components location

Component Location 1. Rear glass defogger relay (Buil-in engine room relay box) 2. Rear glass defogger switch (Dual type) 3. Rear glass defogger switch ( ...

Rear Glass Defogger Switch: Repair procedures

Inspection 1. The windshield deicer switch inputs can be checked using the GDS. 2. To check the input value of windshield deicer switch, se ...

Other information:

Hyundai Creta GS 2014-2025 Service Manual: Tail Gate Latch
Components and components location Component Location 1. Tail gate latch assembly Repair procedures Replacement • Put on gloves to protect yo ...

Hyundai Creta GS 2014-2025 Service Manual: Components and components location
Component Location 1. Windshield wiper arm & blade 2. Wiper & washer switch 3. Windshield washer hose 4. Windshield wiper motor & linkage 5. Washer motor 6. Washer reservoir 7. Front wiper relay (Engine room - PCB Fuse&Relay Block) ...