Hyundai Creta: Steering wheel / Repair procedures

Removal

1.	Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.

2.	Turn the steering wheel so that the front wheels are placed in the straight ahead position.

3.	Loosen the torx bolts which are located on the both side of the steering wheel.

4.	Remove the DAB module then disconnect the clock spring connector (A).

Loosen the steering wheel lock bolt and then separate the steering wheel.

Tightening torque :

39.2 ~ 49.0 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)

•	Do not reuse the bolt.

6.	Install in the reverse order of removal.

Disassembly

1.	Loosen the screw and then remove the lower cover.

2.	Disconnect the remote control connector.

3.	Loosen the screw and then remove the remote contorl switch.

4.	Reassembly in the reverse order of disassembly.

Components 1. Lower cover 2. wiring 3. steering wheel 4. Remote control RH 5. Remote control LH 6. Drive air bag ...

...

Hyundai Creta GS 2014-2019 Service Manual: Repair procedures
On-vehicle Inpection • First of all, check for DTCs. If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide) ...

Hyundai Creta GS 2014-2019 Service Manual: Front Door Belt Inside Weatherstrip: Repair procedures
Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Remove the front door belt inside weatherstrip (A). 3. To install, reverse the removal procedure ...